Depending on distance and size
of dog, use 1 x 1 or 2 x 1 supports along sides of plyboard or use 1/8 or 1/4 inch plyboard.
Measure distance you will need, ie if your dog is strong the angle can be
quite short
One 1 x 1 (or 1 x 2) on each side,
and along top and bottom edge - nail or screw in place
Length of indoor/outdoor carpet or carpet grass which will cover the breadth
of the
plyboard and wrap along the 1 x 1s nail or staple gun in place
OR a Carpet Runner which exceeds length of ramp by at least foot on each end
BEVEL THE EDGES OF THE BOTTOM 1
x 1s at an angle that will accommodate
the ground, if you are so inclined (haha)
The top 1 x 1s can be steadied with a good bottom bevel and the carpet runner
over the top,
or for the bigger dog, get an L bracket and bend to the required angle. Affix
a rubberized
surface to the L bracket to prevent slippage.
On an elbow grease scale this is
about a 3. Go to Home Depot with photos of your best
friend, as I did, cry because your heart is breaking, as I did, buy scraps
and by gum, if
you go, If you cry, they will build it! If they don't it's a fairly simple
project
